LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems (Gasoline) >> Fuel Pump >> Removal & Installation (Except 2.0L & 2.5L)

Removal & Installation (Except 2.0L & 2.5L)

  1. Fuel pump is located in fuel tank and is integral with fuel sending unit assembly. Fuel pump must be replaced with fuel sending unit as an assembly. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable.
  2. Raise and support vehicle. Disconnect fuel lines and electrical connections at fuel tank. Remove fuel tank. Remove fuel sending unit assembly retaining ring or cam lock ring. Lift fuel sending unit assembly from fuel tank. To install, reverse removal procedure using NEW "O" ring and gasket.
scientia non olet · About LEMON Manuals