LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical 3.4L V6 - VIN (E) >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

  1. Open air bleed screw located on thermostat housing (there may be a second bleed screw on water pump). Slowly fill cooling system through radiator neck to base of radiator neck. Wait 2 minutes. Recheck fluid level. Add coolant to restore level to base of radiator neck.
  2. Install radiator cap. Close air bleed screws. Start engine and allow fan to cycle on and off 3 times. Check fluid level.
scientia non olet · About LEMON Manuals