LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel, Display And Gauge System - Analog >> Removal & Installation >> MULTIFUNCTION Switch

MULTIFUNCTION Switch

WARNING: Deactivate air bag system before performing any service operation. See appropriate AIR BAG RESTRAINT SYSTEMS article. DO NOT apply electrical power to any component on steering column without first deactivating air bag system. Air bag may deploy.
CAUTION: Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
  1. Ensure multifunction switch lever is in center position. Disconnect negative battery cable. Disable air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article. Remove air bag module. See appropriate AIR BAG RESTRAINT SYSTEMS article.
  2. Mark steering wheel hub in relation to slash mark on steering shaft for installation reference. Loosen steering wheel shaft nut. Position steering wheel shaft nut flush with end of shaft. Using appropriate steering wheel puller, remove steering wheel.
  3. Remove steering column trim covers. Remove harness straps from harness assembly on steering column. Disconnect multifunction switch assembly harness connector from SIR coil assembly connector. Slide multifunction switch assembly harness connector out of steering column bulkhead connector.
  4. Remove multifunction switch assembly screws from multifunction switch assembly. Remove multifunction switch assembly from steering column tilt head assembly. To install, reverse removal procedure. Tighten multifunction switch assembly screws to 62 INCH lbs (7 N.m). Tighten steering column upper trim cover screws to 13 INCH lbs. (1.5 N.m). Tighten steering column lower trim cover screws to 31 INCH lbs. (3.5 N.m). Tighten steering wheel shaft nut to 33 ft. lbs. (45 N.m).
scientia non olet · About LEMON Manuals