LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Brake Caliper Overhaul (15 Series) >> Assembly Procedure

Assembly Procedure

    Fig 1: Rear Brake Caliper Parts (15 Series)
    GM369670Courtesy of GENERAL MOTORS COMPANY
  1. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the brake caliper bleed screw.

    Tighten 

    Tighten the brake caliper bleed screw to 12 N.m (106 lb in).

  2. Install the brake caliper bleed screw cap.
  3. Lubricate the new piston seal and the brake caliper bore seal groove with brake fluid.
  4. Install the new seal into the brake caliper bore seal groove.
  5. Ensure that the seal is not twisted.
  6. Lubricate the brake caliper bore and the piston with brake fluid.
  7. Install the boot and piston.
    1. Install the boot over the end of the piston so that the fold will face toward the brake caliper housing piston bore opening.
    2. Seat the boot into the brake caliper bore groove. Slide the piston into the brake caliper bore.
    3. Push down the piston to the bottom of the brake caliper bore.
    4. Ensure that the boot is properly seats into the piston groove and into the groove in the brake caliper bore.
  8. Install the brake caliper to the vehicle. Refer to Rear Brake Caliper Replacement (Exc. 35 Series) .
scientia non olet · About LEMON Manuals