LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Brake Caliper Bracket Replacement (Exc. 35 Series) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Disc Brake Hardware & Caliper Bolts
    GM177036Courtesy of GENERAL MOTORS COMPANY
  1. Install the brake caliper bracket (1).
  2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or RED LOCTITE™ #272 to the threads of the bolt.
  3. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the caliper bracket mounting bolts (2).

    Tighten 

    • For vehicles equipped with JC5/JH5 brake systems, tighten the caliper bracket mounting bolts to 200 N.m (148 lb ft).
    • For vehicles equipped with JH6 brake systems, tighten the caliper bracket mounting bolts to 165 N.m (122 lb ft).
    4. Fig 2: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS COMPANY
  4. Install the anti-rattle clips to the brake caliper bracket.
  5. Install the brake pads to the brake caliper bracket.
  6. Slide the brake pads in until they contact the rotor.
  7. Install the brake caliper. Refer to Front Brake Caliper Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
  10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  11. Slowly release the brake pedal.
  12. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
scientia non olet · About LEMON Manuals