LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Brake Caliper Bracket Replacement (35 Series) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS COMPANY
  1. Install the anti-rattle clips to the brake caliper bracket.
  2. Install the brake pads to the brake caliper bracket.
  3. Install the brake caliper to the brake caliper bracket.
  4. Install the brake caliper bolts to the brake caliper mounting bracket. Do not tighten.
    5. Fig 2: View Of Disc Brake Hardware & Caliper Bolts
    GM177036Courtesy of GENERAL MOTORS COMPANY
  5. Install the brake caliper and brake caliper bracket (1) as an assembly.
  6. Perform the following procedure before installing the brake caliper bracket mounting bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or RED LOCTITE™ #272 to the threads of the bolt.
  7. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the caliper bracket mounting bolts (2).

    Tighten 

    Tighten the caliper bracket mounting bolts to 300 N.m (221 lb ft).

  8. Tighten the brake caliper mounting bolts (2).

    Tighten 

    Tighten the brake caliper mounting bolts to 108 N.m (80 lb ft).

  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
  11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  12. Slowly release the brake pedal.
  13. Wait 15 seconds, then repeat steps 11-12 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
scientia non olet · About LEMON Manuals