Trim Covers, Shift Lever Seal - Assemble - Off Vehicle (Floor shift Export)

Tools Required 

J 41352  Modular Column Holding Fixture

Fig 1: Upper Trim Cover & Screws
Courtesy of GENERAL MOTORS COMPANY
1. Install the upper trim cover (2) onto the steering column.
2. Refer to FASTENER NOTICE in Cautions and Notices.

   Screw the 2 TORX® head screws (1) into the upper trim cover (2).

   Tighten 

   Tighten the 2 TORX® head screws to 1.5 N.m (13 lb in).

Fig 2: View Of Lower And Upper Steering Column Covers
Courtesy of GENERAL MOTORS COMPANY
3. Install the lower trim cover onto the upper trim cover in the following way:
   1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
   2. Tilt the lower trim cover up.
   3. Slide the lower trim cover forward until the locking tabs snap into the tab slots.
Fig 3: Lower Trim & Pan Head Tapping Screws
Courtesy of GENERAL MOTORS COMPANY
4. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).

   Tighten 

   Tighten the 2 pan head tapping screws to 3.5 N.m (31 lb in).

Fig 4: Steering Column & J 41352
Courtesy of GENERAL MOTORS COMPANY
5. Remove the steering column and J 41352  from the vise.