Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle (Floor shift Export)

Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle (Floor Shift) .

Fig 1: View Of Steering Column Wire Harness Assembly & Wire Harness Strap

Courtesy of GENERAL MOTORS COMPANY

Remove the wire harness assembly (1) from the wire harness strap (2) and the steering column.
Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.

Fig 2: Turn Signal & Multifunction Switch Assembly Connectors

Courtesy of GENERAL MOTORS COMPANY

Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).

Fig 3: Locating Multifunction Switch Retaining Screws

Courtesy of GENERAL MOTORS COMPANY

Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.