Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle (Column shift Export)
- Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle (Column Shift) .
Courtesy of GENERAL MOTORS COMPANY
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.
Courtesy of GENERAL MOTORS COMPANY
- Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
Courtesy of GENERAL MOTORS COMPANY
- Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
- Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.