Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle (Column Shift)

Tools Required 

J 23653-SIR Lock Plate Compressor

Fig 1: Locating Steering Shaft Assembly Components
Courtesy of GENERAL MOTORS COMPANY
1. Install the following parts onto the steering shaft assembly:
   • The thrust washer (1).
   • The upper bearing spring (2).
   • Lubricate the turn signal cancel cam assembly (3) with lithium grease.
   • The turn signal cancel cam assembly (3).
   • The cam orientation plate (4).
Fig 2: Compressing Cam Orientation Plate
Courtesy of GENERAL MOTORS COMPANY
2. Compress the cam orientation plate using J 23653-SIR .
3. Install the new bearing retainer onto the steering shaft assembly.
4. Firmly seat the bearing retainer into the groove on the steering shaft assembly.
5. Remove J 23653-SIR .
6. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle (Column shift Export) .