LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Standard >> Repair Instructions >> Steering Column Trim Covers Replacement - On Vehicle >> Installation Procedure

Installation Procedure

    Fig 1: Upper Trim Cover & Screws
    GM415299Courtesy of GENERAL MOTORS COMPANY
  1. Install the upper steering column trim cover (2).
  2. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the screws that retain the upper steering column trim cover to the steering column.

    Tighten 

    Tighten the upper steering column trim cover retaining screws to 1.5 N.m (13 lb in).

    3. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS COMPANY
  3. Install the lower steering column trim cover.
  4. Match the tabs slots onto the lower shroud with the locking tabs on the upper shroud.
  5. Tilt the lower shroud up.
  6. Align the shift lever seal into the shrouds.
  7. Slide the lower shroud forward until the locking tabs snap into the tab slots.
    8. Fig 3: Lower Trim & Pan Head Tapping Screws
    GM415298Courtesy of GENERAL MOTORS COMPANY
  8. Install the screws (1) that retain the lower steering column trim cover to the steering column.

    Tighten 

    Tighten the lower steering column trim cover retaining screws to 3.5 N.m (31 lb in).

  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Enable the SIR system. Refer to Enabling the SIR System in SIR.
scientia non olet · About LEMON Manuals