LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Standard >> Repair Instructions >> Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

    Fig 1: Locating Multifunction Switch & Steering Column
    GM245826Courtesy of GENERAL MOTORS COMPANY
  1. Install the multifunction turn signal/hazard switch to the steering column.
  2. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the screws that retain the multifunction switch to the steering column.

    Tighten 

    Tighten the screws to 6 N.m (53 lb in).

    3. Fig 2: Turn Signal & Multifunction Switch Assembly Connectors
    GM306234Courtesy of GENERAL MOTORS COMPANY
  3. Install the gray and black wiring harness connectors (1) to the steering column bulkhead connector.
    4. Fig 3: View Of Steering Column Electrical Connectors
    GM401496Courtesy of GENERAL MOTORS COMPANY
  4. Install the steering column bulkhead connector to the vehicle wire harness.

    Tighten 

    Tighten the center screw to 6 N.m (53 lb in).

  5. Install the wire straps that secure the steering column wiring harness.
  6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  7. Tighten the steering column bracket nuts.

    Tighten 

    Tighten the steering column bracket nuts to 30 N.m (22 lb ft).

  8. Install the knee bolster. Refer to Knee Bolster Replacement (Luxury) , Knee Bolster Replacement (Non-Luxury) in Instrument Panel, Gauges and Console.
  9. Enable the SIR system. Refer to Enabling the SIR System in SIR.
scientia non olet · About LEMON Manuals