LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Standard >> Repair Instructions >> Linear Shift Assembly - Disassemble - Off Vehicle (Column shift Export)

Linear Shift Assembly - Disassemble - Off Vehicle (Column shift Export)

  1. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift) , Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift Snap On Shrouds) .
    2. Fig 1: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the park lock cable assembly (1).
  3. The steering column lock cylinder set should be in the OFF-LOCK position.
  4. Insert a small screwdriver into the slot on the lock module assembly and push against the locking tab to remove.
    5. Fig 2: View Of Park Position Switch Assembly
    GM662195Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the automatic transmission shift lock control connector from the park position switch assembly.
  6. Slide the park position switch assembly off of the linear shift assembly.
    7. Fig 3: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS COMPANY
  7. Remove the automatic transmission shift lock control from the steering column.
  8. Use a small screwdriver to pry the automatic transmission shift lock control from the steering column jacket assembly.
    9. Fig 4: View Of Linear Shift Assembly And Retaining Screws
    GM662202Courtesy of GENERAL MOTORS COMPANY
  9. To break the linear shift assembly down proceed to step 12.
  10. Remove the 3 TORX® screws from the linear shift assembly.
  11. Remove the linear shift assembly from the steering column support assembly.
    12. Fig 5: Cable Shift Cam Assembly And Ball And Actuator Assembly
    GM662173Courtesy of GENERAL MOTORS COMPANY
  12. Remove the 2 hexagon flange head bolts (2).
  13. Remove the ball and actuator assembly (1).
  14. Remove the cable shift cam assembly (3).
    15. Fig 6: shift actuator shaft
    GM662176Courtesy of GENERAL MOTORS COMPANY
  15. Remove the shift actuator shaft.
    16. Fig 7: Actuator Bushings
    GM662186Courtesy of GENERAL MOTORS COMPANY
  16. Remove the 2 actuator bushings.
    17. Fig 8: Shift Lever Gate And Gear Shift Lever Assembly Support Bracket
    GM662190Courtesy of GENERAL MOTORS COMPANY
  17. Remove the 3 oval head screws (2) from the shift lever gate (3).
  18. Remove the shift lever gate (3) from the gear shift lever assembly support bracket (1).
scientia non olet · About LEMON Manuals