Linear Shift Assembly - Assemble - Off Vehicle (Column shift Assemble)

Fig 1: View Of Linear Shift Assembly And Retaining Screws

Courtesy of GENERAL MOTORS COMPANY

If you need to assemble the linear shift assembly first proceed to step 3.
Install the linear shift assembly onto the steering column support assembly.
Refer to FASTENER NOTICE in Cautions and Notices.
Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.

Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

Tighten

Tighten the 3 TORX® screws to 10 N.m (89 lb in).

Fig 2: Shift Lever Gate And Gear Shift Lever Assembly Support Bracket

Courtesy of GENERAL MOTORS COMPANY

Install the shift lever gate (3) onto the gear shift lever assembly support bracket (1).
Install the 3 oval head screws (2) onto the shift lever gate (3).
Tighten

Tighten the 3 oval head screws to 7 N.m (62 lb in).

Fig 3: Actuator Bushings

Courtesy of GENERAL MOTORS COMPANY

Fig 4: shift actuator shaft

Courtesy of GENERAL MOTORS COMPANY

Fig 5: Cable Shift Cam Assembly And Ball And Actuator Assembly

Courtesy of GENERAL MOTORS COMPANY

Install the cable shift cam assembly (3).
Install the ball and actuator assembly (1).
Install the 2 hexagon flange head bolts (2).
Tighten

Tighten the 2 hexagon flange head bolts to 18 N.m (13 lb ft).

Fig 6: View Of Automatic Transmission Shift Lock Control Actuator

Courtesy of GENERAL MOTORS COMPANY

Install the automatic transmission shift lock control.
Install the shift lever clevis and put the column in the neutral position.

This will be 2 positions from the park position.

Fig 7: View Of Park Position Switch Assembly

Courtesy of GENERAL MOTORS COMPANY

Slide the park position switch assembly onto the linear shift assembly.
Connect the automatic transmission shift lock control connector onto the park position switch assembly.

Fig 8: Identifying Park Lock Cable At Ignition Lock Cylinder

Courtesy of GENERAL MOTORS COMPANY

Connect the park lock cable assembly (1) to the lock module assembly in the following way:
- Place the steering column lock cylinder set into the off position.
- Place the shift lever clevis into the park position.
- Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds) , Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift) .