Installation Procedure

Fig 1: Ignition Switch & Lock Module

Courtesy of GENERAL MOTORS COMPANY

Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case

Courtesy of GENERAL MOTORS COMPANY

Install the key alarm connector (1) into the lock module assembly (2).
1. Push the key alarm connector (1) into the lock module assembly (2).
2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
Install the passkey connector into the lock module assembly (2).

Fig 3: Electric Park Lock & Connector

Courtesy of GENERAL MOTORS COMPANY

Install the connector (2) to the electric park lock (1), for vehicles equipped with floor shifters.

Fig 4: Turn Signal & Multifunction Switch Assembly Connectors

Courtesy of GENERAL MOTORS COMPANY

Slide the 2 connectors (2) of the turn signal and multifunction switch into the bulkhead connector (1).

Fig 5: View Of Steering Column Wire Harness Assembly & Wire Harness Strap

Courtesy of GENERAL MOTORS COMPANY

Attach the wire harness assembly (1) to the steering column wire harness strap (2).

Fig 6: View Of Steering Column Electrical Connectors

Courtesy of GENERAL MOTORS COMPANY

Connect the steering column electrical connectors to the vehicle.
Install the trim covers to the column. Refer to Steering Column Trim Covers Replacement - On Vehicle .
Install the knee bolster. Refer to Knee Bolster Replacement (Luxury) , Knee Bolster Replacement (Non-Luxury) in Instrument, Panel, Gauges and Console.
Enable the SIR system. Refer to Enabling the SIR System in SIR.
It may be necessary to reprogram the theft deterrent system if the module was replaced. Refer to Programming Theft Deterrent System Components in Theft Deterrent.