MULTIFUNCTION Alarm Module Replacement: Removal
CAUTION:
Before servicing any electrical component, ignition key must be in LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool could easily come in contact with a live exposed electrical terminal, disconnect negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to vehicle or its components.
- Disconnect negative battery cable.
- Remove left body hinge pillar trim panel.
- Remove 2 bolts securing instrument panel driver's side knee bolster trim. Position trim as necessary to gain access to instrument panel driver's side knee bolster reinforcement.
- Remove 2 bolts securing reinforcement and instrument panel driver's side knee bolster reinforcement.
- Remove instrument panel driver's side knee bolster reinforcement.
- Remove screw from junction block No. 2 and position junction block in order to gain access to multifunction alarm module.
- Disconnect 2 multifunction alarm module electrical harness connectors.
- Disconnect multifunction alarm module (2) from rear of junction block No. 2 (1). See Fig 1 .