LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Automatic Transaxle Diagnosis - 4T65-E) >> Removal & Installation >> Powertrain Control Module >> Installation

Powertrain Control Module: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2001 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the connectors (2) to the PCM (1). Tighten the connectors to 71 INCH lbs. (8 N.m). See Fig 3 .
  2. Install the PCM (3) into the air cleaner housing assembly.
  3. Install the air cleaner housing cover (1). See Fig 2 .
  4. Tighten the retaining screw (2) for the air cleaner cover.
  5. Reconnect the air duct (3) to the throttle body (1), and tighten the band clamp (2) at the throttle body. See Fig 1 .
  6. Reconnect the electrical connectors for the IAT sensor and the MAF sensor.
  7. Install the strut brace.
  8. Connect the negative battery cable.
  9. If a new PCM is being installed, program the EEPROM. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
Fig 1: Removing & Installing PCM (1 Of 3)
G00075758Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing PCM (2 Of 3)
G00075759Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing PCM (3 Of 3)
G00075760Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals