Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.

Body surfaces and decals must be maintained between 21-38°C (70-100°F) during installation.
Never apply decals when body surface and decal temperatures are below 21 °C (70°F).
Stripes and decals may be applied dry. If this does not result in a consistent bubble free application, the WET method must be used as in the case of large graphics packages.
Stripes or decals that are applied on flexible surfaces (fascias, etc.) must be applied using the WET method. This will reduce the formation of bubbles under the decal due to the outgassing potential of the flexible materials.