LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Plate Replacement - IP Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat heater switches to the IP accessory trim plate, if equipped.
  2. Connect the IP harness seat heater leads, if equipped.
  3. Align the IP accessory trim plate retainers to the openings in the IP trim pad.
  4. Press the IP accessory trim plate to the IP trim pad. Make sure the retainers are fully seated.
  5. Install the front floor console trim plate. Refer to Trim Plate Replacement - Front Floor Console .
    Fig 1: Installing IP Accessory Trim Plate
    G01830869Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals