LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Plate Replacement - Front Floor Console >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the front floor console trim plate to the front floor console.
  2. Install the traction control switch to the front floor console trim plate. Refer to TRACTION CONTROL SWITCH REPLACEMENT .
  3. Install the front floor console trim plate to the front floor console pressing into place until fully seated.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the screws to front floor console trim plate.

    Tighten 

    Tighten the front floor console trim plate screws to 2N.m (18 lb in).

  5. Close the front floor console cupholder.
  6. Lower the front floor console armrest.
    Fig 1: Installing Front Floor Console Trim Plate & Screws
    G01830931Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals