LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (IP) Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sunload sensor into the opening in the IP upper trim panel. Rotate the sensor clockwise to secure.
  2. Position the DRL ambient light sensor into the opening in the IP upper trim panel. Rotate the sensor clockwise to secure.
    Fig 1: Installing (DRL) Ambient Light Sensor & Sunload Sensor
    G01830872Courtesy of GENERAL MOTORS CORP.
  3. Align the upper trim locating pins and the retainers to the slots in the instrument panel.
  4. Push forward and down on the IP upper trim panel to lock into place.
  5. Install the windshield garnish molding. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
    Fig 2: Installing IP Upper Trim Panel
    G01830873Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals