LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Pad Replacement - IP >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
  2. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  3. Remove the right and the left instrument panel (I/P) access hole covers. Refer to Instrument Panel (IP) Outer Trim Cover Replacement .
  4. Remove the I/P insulators. Refer to Closeout/Insulator Panel Replacement - Right  and to Closeout/Insulator Panel Replacement - Left .
  5. Remove the front carpet retainers. Refer to CARPET RETAINER REPLACEMENT - FRONT .
  6. Remove the windshield upper garnish moldings. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
  7. Remove the I/P upper trim panel. Refer to Trim Panel Replacement - Instrument Panel (IP) Upper .
  8. Remove the front floor console. Refer to Console Replacement - Front Floor .
  9. Remove the steering column filler. Refer to Steering Column Filler Replacement .
  10. Disconnect the data link connector.
    Fig 1: View Of Data Link Connector
    G01830896Courtesy of GENERAL MOTORS CORP.
  11. Remove the knee bolster. Refer to Knee Bolster Replacement .
  12. Remove the steering column. Refer to STEERING COLUMN REPLACEMENT .
  13. Remove the hood release handle. Refer to HOOD LATCH RELEASE HANDLE REPLACEMENT .
  14. Remove the I/P cluster trim plate. Refer to Trim Panel Replacement - IP Cluster .
  15. Remove the I/P cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
  16. Remove the I/P accessory trim plate. Refer to Trim Plate Replacement - IP Accessory .
  17. Remove the radio. Refer to RADIO REPLACEMENT .
  18. Remove the HVAC control module. Refer to HVAC CONTROL ASSEMBLY in HVAC Systems - Automatic and HVAC MODULE ASSEMBLY in HVAC Systems - Manual.
  19. Remove the I/P lighter. Refer to Cigar Lighter Replacement - IP .
  20. Remove the ignition switch. Refer to Ignition Switch Replacement .
  21. Remove the hazard warning and cruise control switch. Refer to Hazard Warning and Cruise Control Switch Replacement .
  22. Remove the switch bank. Refer to IP Multifunction Switch Assembly Replacement .
  23. Remove the air temperature sensor. Refer to INSIDE AIR TEMPERATURE SENSOR in HVAC Systems - Automatic.
  24. Remove the I/P compartment. Refer to Compartment Replacement - IP .
  25. Remove the I/P compartment lamp switch. Refer to IP Compartment Lamp Switch Replacement .
  26. Reposition the fuse block.
  27. Remove the driver side I/P trim pad bolts from the hinge pillar.
    Fig 2: Removing Driver Side I/P Trim Pad Bolts From Hinge Pillar
    G01830897Courtesy of GENERAL MOTORS CORP.
  28. Remove the passenger side I/P trim pad bolts from the hinge pillar.
    Fig 3: Removing Passenger Side I/P Trim Pad Bolts From Hinge Pillar
    G01830898Courtesy of GENERAL MOTORS CORP.
  29. Remove the I/P trim pad bolts from the cluster pocket.
  30. Remove the I/P trim pad bolts near the windshield.
  31. Reposition the I/P wiring harness.
  32. Remove the I/P trim pad from the vehicle.
    Fig 4: Removing I/P Trim Pad, Wiring Harness & Bolts
    G01830899Courtesy of GENERAL MOTORS CORP.