LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Power Accessory Port Replace - Front Floor Console >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the front floor console power accessory port housing from the front floor console by using a small flat-bladed tool to release the retainer.
    Fig 1: Using Small Flat Bladed Tool Release Retainer
    G01830932Courtesy of GENERAL MOTORS CORP.
  2. Remove the front floor console power accessory port housing from the front floor console.
    Fig 2: Removing Front Floor Console Power Accessory Port Housing From Front Floor Console
    G01830933Courtesy of GENERAL MOTORS CORP.
  3. Release the electrical connector retainer tabs from the power accessory port.
    Fig 3: Removing Electrical Connector Retaining Tabs From Power Accessory Port
    G01830934Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the power accessory port.
    Fig 4: Removing Electrical Connector From Power Accessory Port
    G01830935Courtesy of GENERAL MOTORS CORP.
  5. Remove the power accessory port element retainer.
  6. Remove the power accessory port element.
    Fig 5: Removing Power Accessory Port Element Retainer & Element
    G01830936Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals