LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the instrument panel knee bolster bracket to the instrument panel.
    Fig 1: Installing Knee Bolster Bracket To IP
    G01830866Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts to the instrument panel knee bolster bracket.

    Tighten 

    Tighten the instrument panel knee bolster bracket bolts to 6 N.m (53 lb in).

  3. Install SIR connector clip.
  4. Install bolts to the data link connector.

    Tighten 

    Tighten the data link connector bolts to 2 N.m (18 lb in).

  5. Install the hood release lever. Refer to HOOD LATCH RELEASE HANDLE REPLACEMENT .
  6. Install the instrument panel steering column opening filler. Refer to Steering Column Filler Replacement .
    Fig 2: Installing Bolts To Knee Bolster Bracket
    G01830867Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals