Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
- Recode the ignition switch lock cylinder, if necessary. .
- Insert the key and turn the ignition switch lock cylinder to the ON position.
- Align the ignition switch lock cylinder to the ignition switch, then press into place.
- Turn the key to the OFF position and remove the key.
- Install the radio. Refer to RADIO REPLACEMENT .
- Align the ignition switch bezel slots to the tabs on the ignition switch lock cylinder and press into place until fully seated.
- Connect negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
- Perform the BCM theft deterrent relearn procedure, if the ignition switch lock cylinder was replaced. Refer to BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION .