LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> IP Multifunction Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel (I/P) steering column opening filler. Refer to Steering Column Filler Replacement .
  2. Remove the screws from the switch bezel.
  3. Pull the switch bezel from the I/P trim pad.
  4. Disconnect the electrical connectors.
  5. Disengage the switch retainers. Remove the I/P lamp dimmer switch, the fog lamp switch, and the rear compartment lid release switch from the switch bezel, as required.
    Fig 1: Removing (I/P) Steering Column Filler, Electrical Connectors & Screws
    G01830834Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals