LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> IP Multifunction Switch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the I/P lamp dimmer switch, the fog lamp switch, and the rear compartment lid release switch to the switch bezel, as required.
  2. Connect the electrical connectors.
  3. Align the switch bezel to the I/P trim pad.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the switch bezel screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  5. Install the I/P steering column opening filler. Refer to Steering Column Filler Replacement .
    Fig 1: Installing (I/P) Steering Column Filler, Electrical Connectors & Screws
    G01830835Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals