LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Hood Release Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood release cable to the hood release handle.
    Fig 1: Installing Hood Release Cable To Hood Release Handle
    G01830862Courtesy of GENERAL MOTORS CORP.
  2. Install the hood release handle to the instrument panel.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the bolts to hood release handle base.

    Tighten 

    Tighten the hood release handle base bolts to 2 N.m (18 lb in).

  4. Install the instrument panel steering column filler. Refer to Steering Column Filler Replacement .
    Fig 2: Installing Bolts To Hood Release Handle Base
    G01830863Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals