LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Cupholder Replacement - Front Floor Console >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spring to the front floor console, by inserting the spring up into the slot.
    Fig 1: Installing Spring To Front Floor Console
    G01830943Courtesy of GENERAL MOTORS CORP.
  2. Insert a flat-bladed tool under the spring and lift the spring up to allow space for the cupholder.
  3. Position the left side pivot pin of the rear cupholder into the pivot point in the front floor console.
  4. Press the rear cupholder to the left making enough space to insert the right side into the right pivot point.
  5. Release the spring and remove the flat-bladed tool.
  6. Inspect the rear cupholder for proper operation.
    Fig 2: Installing Rear Cupholder & Pivot Pin
    G01830944Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals