Filling Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue, 2001 Oldsmobile Intrigue, and 2000 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 23688 Coolant and Battery Fluid Tester

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Close the radiator drain cock.
Tighten

Tighten the radiator drain cock to 2 N.m (18 lb in).
If the engine block drain plug was removed, perform the following:
- Apply pipe sealer to the drain plug.
- Install the drain plug.
Tighten

Tighten the drain plug to 22 N.m (16 lb ft).
Lower the vehicle.
Open the cooling system bleeder screws.
Important: Use a 50/50 mixture of DEX-COOL antifreeze and deionized water.
Slowly fill the cooling system with a 50/50 coolant mixture.
Close the cooling system bleeder screws.
Install the coolant pressure cap.
Start the engine.
Run the engine at 2,000-2,500 RPM until the engine reaches normal operating temperature.
Allow the engine to idle for 3 minutes.
Shut the engine off.
Allow the engine to cool.
Top off the coolant as necessary.
Inspect the concentration of the engine coolant using the J 23688 .
Rinse away any excess coolant from the engine and the engine compartment.
Inspect the cooling system for leaks.