LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (HVAC Systems - Automatic) >> Removal & Installation >> Temperature Actuators >> Installation (Left)

Installation (Left)

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the left air temperature actuator, then align the slots in the electric actuator driver to the flats on the temperature shaft. Align the locating hole to the alignment pin on the HVAC module cases. Slide the actuator driver on to the shaft.
  2. The actuator driver should seat completely on to the shaft and the mounting holes should be flush with the mounting bolts on the HVAC module case. Install the mounting screws to the left air temperature actuator.
  3. Connect the electrical connector to the left air temperature actuator. Install the knee bolster bracket. Install the left I/P insulator. Recalibrate the actuator. See RE-CALIBRATING ACTUATORS .
scientia non olet · About LEMON Manuals