LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Automatic Transmission Removal & Installation) >> Removal & Installation >> Engine Mount Bracket (Right Side) >> Notes

Engine Mount Bracket (Right Side): Notes

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right engine mount bracket assembly. See ENGINE MOUNT (RIGHT SIDE)  .
  2. Remove the right upper engine mount nuts. See Figure .
  3. Remove the engine mount bracket from the right engine mount.
  4. Inspect the right engine mount bracket.
  5. Inspect the right mount.
  6. Replace the engine mount if the engine mount exhibits any of the following conditions:
    • The hard rubber surface is covered with heat check cracks.
    • The rubber is separated from the metal plate of the engine mount.
    • The rubber is split through the center of the engine mount.
scientia non olet · About LEMON Manuals