LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Impala Base, 3.8 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Automatic Transmission Removal & Installation) >> Removal & Installation >> Engine Mount (Right Side) >> Removal

Engine Mount (Right Side): Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery cable.
  2. Remove the engine mount strut with the engine mount strut bracket at the upper radiator support.
  3. Install appropriate engine support fixture.
  4. Raise and support the vehicle.
  5. Remove the right (rear) lower engine mount nuts.
  6. Remove the left (front) lower engine mount nuts.
  7. Remove the right front tire and wheel.
  8. Use the engine support fixture in order to raise the engine.
  9. Remove the power steering cooler pipe bracket.
  10. Remove the right engine mount bracket bolts. See Fig 1 .
  11. Remove the right engine mount bracket assembly from the vehicle. See Fig 1 .
  12. Remove the right upper engine mount nuts. See Fig 2 .
  13. Remove the right engine mount from the engine mount bracket. See Fig 2 .
    Fig 1: Removing/Installing Right Engine Mount Bracket & Bolts
    G00199848Courtesy of GENERAL MOTORS CORP.
    Fig 2: Removing/Installing Right Upper Engine Mount & Nuts
    G00199849Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals