Scan Tool: Notes

The scan tool has several features that can be used to help locate an intermittent condition. When scan tool is used for system tests, it will display values actually seen or commanded by various systems (i.e., BCM, PCM). This will usually include the following types of information:

• Analog Data Input
  
  Displays analog input seen by system.
• Inputs/Outputs
  
  Displays digital values as seen by system, and provides indication of whether input or output has cycled.
• Special Functions (Output Controls)
  
  Allows for outputs of system to be set at a desired value (ON or OFF). This will only indicate if IPC is sending the appropriate commands, not what action was actually taken.
• Clear Codes
  
  Will erase DTCs for system currently selected (if problem still exists in system, DTC may immediately reset).