LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 354 (Seat System) >> Repair Instructions >> Lumbar Actuator Replacement - Manual >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable end (2) to the actuator (1). Rotate the cable end (2) 90 degrees downward.
  2. Install the cable conduit (3) to the retainer on the actuator (1). Press the cable conduit (3) into retainer on the actuator (1) until fully engaged.
  3. Install the actuator (1) to the seat cushion frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Through the opening in the seat cushion cover, install the actuator screws.

    Tighten 

    Tighten the screw to 1.2 N.m (10 lb.in).

  5. Align the actuator knob to the splines on the actuator (1). Press the actuator knob until fully engaged on the actuator (1).
    Fig 1: Installing Actuator To Seat Cushion Frame
    G01559898Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals