LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 353 (Sunroof System) >> Repair Instructions >> Sunroof Drive Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Do not kink the cables. Replace the cables if they are kinked. Replace the cables in pairs. Sunroof cables have a flexible sealer at the tray assembly. Ensure that the seal is not broken during cable removal or installation.
Fig 1: Installing Sunroof Drive Cables Into Guide Tubes
G01559855Courtesy of GENERAL MOTORS CORP.
  1. Hold the sunroof drive cable tubes in position.
  2. Push the sunroof drive cables into the guide tubes.
  3. Engage the sunroof drive cables into the guide assemblies.
  4. Install the sunroof drive cable retainers. Seat the cable housing flair firmly into the module tray groove.
  5. Connect the sunroof motor/actuator.
  6. Install the sunroof window. Refer to SUNROOF WINDOW REPLACEMENT  .
    Fig 2: Installing Sunroof Drive Cable Retainers
    G01559856Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals