LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Exterior Trim) >> Repair Instruction >> Emblem/Nameplate Replacement - Door >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
Fig 1: Identifying Installing Dimension Of SUNFIRE Emblem
G01559406Courtesy of GENERAL MOTORS CORP.
  1. Clean the area where the emblem/nameplate will be installed.

    Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a, 50/50 mixture, by volume of isopropyl alcohol and water to clean the area.

  2. Dry the area thoroughly.
  3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
  4. For the SUNFIRE emblem/nameplate, install to the following dimensions:
    • Dimension (a) is 57 mm (2.250 in) from the front edge of the door to the front of the emblem/nameplate.
    • Dimension (b) is 39 mm (1.500 in) from the top of the door molding to the bottom of the emblem/nameplate.
  5. For the SUNFIRE GT emblem/nameplate, install to the following dimensions:
    • Dimension (a) is 57 mm (2.250 in) from the front edge of the door to the front of the emblem/nameplate.
    • Dimension (b) is 26 mm (1.024 in) between the SUNFIRE and the GT emblem/nameplate.
    • Dimension (c) is 39 mm (1.535 in) from the top of the door molding to the bottom of the emblem/nameplate.
    Fig 2: Identifying Installing Dimension Of SUNFIRE GT Emblem
    G01559407Courtesy of GENERAL MOTORS CORP.
  6. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070  , if necessary.
  7. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
    IMPORTANT: Do not touch the adhesive backing on the emblem/nameplate.
  8. Remove the protective liner from the back of the emblem/nameplate.
  9. Position the emblem/name plate to the location marks and press the emblem/nameplate to the mounting surface.
  10. Apply equal pressure along the emblem/name plate to uniformly bond the item to the mounting surface.
  11. Remove the protective tape from the mounting surface.
scientia non olet · About LEMON Manuals