LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 345 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory (Chevrolet) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector for the cigar lighter, if equipped.
  2. Connect the electrical connectors for the headlamp dimmer switch.
  3. Align the retaining tabs (2) with the I/P carrier.
  4. Install the I/P trim plate (3). Press the plate into the I/P carrier to engage the retainers (2).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the screws (1) to the I/P trim plate (3).

    Tighten 

    Tighten the screws to 2.3 N.m (20 lb in).

  6. Install the I/P trim pad. Refer to TRIM PAD REPLACEMENT - INSTRUMENT PANEL (I/P) (CHEVROLET)  or TRIM PAD REPLACEMENT - INSTRUMENT PANEL (I/P) (PONTIAC)  .
  7. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM , and DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
    Fig 1: Installing Screws To I/P Trim Plate (Chevrolet)
    G01559230Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals