Daytime Running Lamps (DRL)

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Any function that turns on the headlights will cancel the daytime running lamps operation. The LT HDLP fuse in the IP fuse block supplies battery positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will turn on the daytime running lamps. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit at G204. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the RUN position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met the DRL will illuminate.

DRL operation in Manual Transmission equipped vehicles will occur when the ignition switch is in the RUN position, and the parking brake is released.