Installation (2.2L - LN2 Engine)
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Position the starter to the engine. See Figure .
- Install the starter bolts. Tighten bolts to 37 Ft. Lbs. (50 N.m).
- Install the electrical connections to starter.
- Install flywheel inspection shield. See Figure .
- Lower the vehicle.
- Install wiring harness bracket nut to starter bolt.
- Install the negative battery cable.