LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Installation

Brake Pedal Assembly: Installation

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal assembly. Install the upper and the lower mounting nuts to the brake pedal assembly. Tighten the mounting nuts to 20 INCH lbs (27 N.m).
  2. Connect the brake pedal pushrod to the brake pedal. Connect the electrical harness to the brake pedal. Install the brake switch to the brake pedal. Adjust the brake switch.
  3. Connect the accelerator cable to the accelerator pedal.
Fig 1: Removing & Installing Brake Pedal Assembly
G00076358Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals