Rear Brake Shoes
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Release parking brake. Raise and support vehicle. Mark relationship of wheels to wheel studs. Remove wheels. Mark relationship of drums to wheel studs. Remove drums.
- Using Brake/Drum Shoe Clearance Gauge (J-21177-A), measure inner diameter of brake drum. Turn star wheel on adjusting screw assembly until brake shoe diameter is .030" (.76 mm) less than inner drum diameter measured. Repeat procedure for other rear brake assembly.
- Install drums and wheels, aligning marks made during removal. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS . Lower vehicle. Firmly apply and release service brakes several times while driving forward and backward.