Power Steering Pump Pulley: Installation

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: NEVER use a hammer to install the power steering pulley. The face of the power steering pulley hub must be flush with the end of the power steering pump driveshaft.

Using Pulley Installer (J-25033-C), install pulley onto power steering pump. To complete installation, reverse removal procedure. Fill and bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION. Check for leaks.