Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble (Off Vehicle): Assembly
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the upper bearing inner race (4).
- Install the upper bearing spring (3).
- Install the turn signal cancel cam (2).
- Lubricate the turn signal cancel cam (2) with lithium grease.
- Install the shaft lock (1).
- Install the bearing retainer using J 23653-SIR and J 42137 .
- Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Disassemble (Off Vehicle) .
- Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .