Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
If steering column to cowl panel seal is torn or otherwise damaged, it must be replaced. Confirm that the seal and inner race are properly located. Failure to do so may allow carbon monoxide into the vehicle, which may result in serious personal injury or death.
- Install the intermediate steering shaft and the intermediate steering shaft seal to the vehicle.
- Install the upper pinch bolt to the steering column. Tighten the bolt to 40 N.m (30 lb ft).
- Raise the vehicle on a hoist.
- Install the lower pinch bolt to the steering gear. Tighten the bolt to 40 N.m (30 lb ft).
- Install the left tire and wheel.
- Lower the vehicle.