LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Automatic Transaxle - 4T40-E/4T45-E - Overhaul) >> Repair Instructions >> Torque Converter Seal Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cross Sectional View Of J 41103 & Components
    GM20211Courtesy of GENERAL MOTORS CORP.
  1. Insert the three J 41103-1  puller legs under the Torque Converter Seal (54).
  2. Insert the J 41103-3  support body over the stator shaft (43).
  3. Insert the J 41103-2  puller bridge over the J 41103-3  support body. Connect the J 41103-1  puller legs into the slots on the J 41103-2  bridge.
    4. IMPORTANT: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.
  4. Tighten the forcing screw on the J 41103-2  puller bridge until the J 41103-1  puller legs remove the torque converter seal (54).
scientia non olet · About LEMON Manuals