LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Automatic Transaxle - 4T40-E/4T45-E - Overhaul) >> Repair Instructions >> Torque Converter Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbine Shaft O-Ring
    GM20155Courtesy of GENERAL MOTORS CORP.
  1. Install a new turbine shaft O-ring (41) on the end of the turbine shaft.
    2. CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
  2. Install the torque converter onto the transmission.
  3. Install the J 21366  .
  4. Remove the transmission from the holding fixture.
scientia non olet · About LEMON Manuals