LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Automatic Transaxle - 4T40-E/4T45-E - Overhaul) >> Repair Instructions >> Selective Washer Measurement and Installation >> Measurement and Installation Procedure

Measurement and Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Measuring Distance Between Clutch Housing and Case
    GM474253Courtesy of GENERAL MOTORS CORP.
  1. Place the J 34673  across the machined surface of the case.
  2. Measure the distance between the top of the direct/coast clutch housing (105) and the machined surface of the case (record measurement).
  3. Note the recorded measurement and choose the correct selective washer. Refer to End Play Specifications .
    4. Fig 2: Expanded View Of Thrust Bearing
    GM474254Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Position the tab, on the selective thrust washer (104), in the recessed area for the retainer and ball assembly (105).
  4. Assemble the selective thrust washer (104) onto the top of the input housing.
  5. Assemble the thrust bearing (103) over the input shaft and onto the top of the selective thrust washer (104).
scientia non olet · About LEMON Manuals