Oil Feed Pipes Assemble
WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the oil feed pipes (83) for plugged passages, bent pipes, or cracks.
- Inspect the oil feed pipe seal rings (82) in order to verify the proper location of the seal rings (82).
- Replace the seal rings (82) only if they are cut, swelled or damaged.
- Clean and dry the oil feed pipes.
- Install new oil feed pipe seal rings (82) if necessary.
- Retain any newly installed oil feed pipe seal rings (82) with J 36850 or equivalent.
- Install the oil feed pipe assembly (83) onto the transmission case (51).
- Install the four oil feed pipe bolts (81). Hand start the bolts.
Tighten: Tighten the bolts to 12 N.m (9 lb ft).
IMPORTANT:
The oil feed pipe seals are glued into place during initial assembly. If you must replace a seal ring, be sure to thoroughly clean any residual glue from the oil feed pipes.
NOTE:
Refer to Fastener Notice in Cautions and Notices.