LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Automatic Transaxle - 4T40-E/4T45-E - Overhaul) >> Repair Instructions >> Manual Shift Shaft, Detent Lever, and Park Lock Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Manual Shaft Seal
    GM20220Courtesy of GENERAL MOTORS CORP.
  1. Install a new manual shaft seal (809) into the case (51). Use a 13 mm socket.
    2. Fig 2: View Of Parking Lock Actuator Assembly & Manual Shaft And Detent Lever Assembly
    GM20209Courtesy of GENERAL MOTORS CORP.
  2. With the manual valve to detent lever link (802) and the parking lock actuator assembly (807) attached, install the manual shaft and detent lever assembly (806) into the case.
  3. Ensure that the parking lock actuator rod is correctly positioned into the actuator guide.
    4. Fig 3: Installing Manual Shaft Pin With J 41229
    GM20221Courtesy of GENERAL MOTORS CORP.
    NOTE: Use J 41229  to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.
  4. Install the manual shaft pin (803) into the case. Use the J 41229  .
scientia non olet · About LEMON Manuals